示例图片二

路面抛丸机如何使用

  路面抛丸机使用方法

  一、路面抛丸机正确的开机过程

  1、敞开吸尘器。

  2、断定阀门手柄处于“封闭”方位按压“操控开”行走,按压“抛丸开”,抛丸器发动,调查电流表,在抛丸电机发动时需要较大的电流,直到电机到达必定的转速;当电机到达额外转速,电流会下降到无负载电流状况。

  3、设定行走方向“向后”,设备行走,然后再行走速度调节钮处设定设备行走速度。

  4、当在混凝土外表清理时,只要在机器行走的时分,才能够打开阀门,不然很短的时刻就会在混凝土外表抛打出坑。

  二、路面抛丸机正确的停机过程

  1、安全封闭阀门手柄。

  2、铺开行走捏合手柄,行走电机中止。

  3、按压赤色“操控关”按钮。

  4、过几分钟后,按压吸尘器上的“电扇关”和“压缩关”。

路面抛丸机

  Using method of pavement shot blasting machine

  First, the correct opening process of the pavement shot blasting machine

  1. Open the vacuum cleaner.

  2, concluded that the valve handle is in the "off" position pressing "control" walking, "shot", press the shot blasting machine launch, investigation of current meter, require a large current in the blast motor, until the motor reaches a certain speed; when the motor reaches the extra speed, the electric current will drop to no load current condition.

  3, set the direction of walking "backward", equipment walking, and then walk speed adjustment button to set the speed of the equipment.

  4, when cleaning the concrete surface, as long as the machine is walking, it will be able to open the valve, otherwise, it will be thrown out of the pit on the concrete surface in a short time.

  Two. The correct shutdown process of the pavement shot blasting machine

  1. Seal the valve handle safely.

  2, spread the handle of kneading and kneading, and stop the walking motor.

  3, press the red "control" button.

  4. After a few minutes, press the "electric fan" and "compress" on the vacuum cleaner.